1.Power: 149kW (Including one hydraulic pump 75 kW, two large-turn 22kW motors, and four small-turn 7.5kW motors. Does not include the power used to decorate lighting and sound.)
2.Capacity: 32 persons
3.Work Height: 9.9m
4.Equipment Height: 6.8m
5.Large turning diameter: 11.5m
6.Small turning diameter: 3.5m
8.Rotation speed: 8-12/min
10.Carrying capacity: 384 persons/h
11.Service life: 8 years (Calculated from the date of shipment)
13.Ground carrying capacity: ≥150KPa , Ground flatness ≤3%
The take off ride consists of a base, a hoisting arm, a swivel arm, a swivel arm lands, a size dial, a seat combination, a transmission system, a hydraulic system, and an electrical control system.
Base: It adopts box structure to increase its rigidity and strength. It has the characteristics of simple structure, stable and beautiful appearance, high rigidity and convenient installation.
Lifting arm: It adopts a box structure, and the bottom and the base are connected by a pin. The middle part is connected to the middle of the base through the oil cylinder, and the tilting angle is raised and lowered during operation.
Slewing arm: It is the main support arm of the big turntable, and also the support arm of the four small turntables.
Slewing arm splicing plate: It is a component that connects the hoisting arm and the large turntable.
Seat combination: It consists of a seat, a safety press bar and so on.
Hydraulic system: consists of a hydraulic motor, a fuel tank, a control section and an actuator that powers the lift cylinder of the equipment.
Transmission system: It consists of a reducer, a transmission gear, a slewing ring, and a swivel arm.
Electrical Control System: A control hub for hydraulic, mechanical and electrical components.
The principle of operation of the device is as follows:
After the passengers are seated on the seat in turn, activate the safety bar locking system and fasten the seat belts one by one and check the tightnes